This article is more than 1 year old

Bloke hews plywood Raspberry Pi tablet

Thick as two short planks, but deliciously woody

It's a tip of the hat today to Michael Castor, who caught our eye with his attractive fusion of plywood, carbon fibre and Raspberry Pi, dubbed the "PiPad".

Top view of the PiPad

Michael's plan was to build an "all-in-one system that was usable, portable, and Linux-based", but which also "had to look good". Furthermore, it needed to be sufficiently innocuous for in-flight use without provoking a complete shutdown of US airspace.

Handily, Michael had the use of a CNC router to hew the case from 12mm plywood...

CNC router cutting the PiPad wooden frame

...although he had to find less hi-tech solutions for other manufacturing challenges:

A drill with a spirit level taped to the top

It's not clear quite what purpose this modified DeWalt served, but we assume it played a part in cutting the connector apertures in the frame:

The PiPad plywood frame with connection apertures cut out

For a cutting edge design touch, the base features a sheet of carbon fibre...

The base of the PiPad with the electronics installed

... and here are the guts of the finished beast:

An internal view of the finished PiPad

The screen is a 10-inch LCD capacitive touchscreen with a 5V HDMI-LVDS converter board, meaning the thing runs off the same voltage as the Pi. A phone charger provides external power, with an onboard 10,000mAh good for around 6 hours run time.

The completed PiPad with keyboard, headphones and mouse

Michael finished the build in two weeks, in time to hop on a plane to San Francisco for the Maker Faire Bay Area. Suffice it to say, the PiPad didn't provoke a diversion to the alternative Bay at Guantanamo, and Michael says his movie choice of Talladega Nights attracted a favourable review from one flight attendant.

The PiPad showing a movie during a flight

Raspberry Pi head honcho Eben Upton was similarly impressed at the Maker Faire New York, where he signed the PiPad on its sleek black backside.

The back of the PiPad, signed by Eben Upton

Michael told El Reg that the whole thing costs around $350. He said: "I could have bought an iPad or an Android tablet for that (or less) but what's the fun in that?"

Quite so, but we did question his use of plywood. He defended: "I chose the birch ply for a few reasons; it machines well, I had some lying around, and it looks nice without costing a bundle."

When pressed as to whether he might consider a deluxe version in perhaps mahogany or cocobolo, Michael responded: "I've thought about making one out of a nice hardwood with an inlay... maybe someday."

There's more on the PiPad build here, and further photos here. ®

More about

TIP US OFF

Send us news


Other stories you might like